New to Parsix, tried to hibernate and hangs on resume

[keepitsimpleengineer]

New clean install on Lenovo S12 (intel atom) dimutative laptop.

Tried suspend - and it worked! ! !

But when I tested hibernate - it seems to hang with a message "2 sec..." on a blank screen with a text message.

How can I get Parsix to boot normally? safe mode from grub2 does the same thing as regular boot.

Any suggestions, folks?

[alan]

Hi, So if fails to resume but it does finish the hibernation process and shuts down the system? How much RAM you have and how big is your swap partition?

[Haiku]

Yes, I have the same issue when i set that when the lids close then hibernate and than it will never came back and hangs...
i have 6GB DDR3 Ram and about 8GB Swap but I run the 32bit version so the Ram used is about 4GB of my whole Ram.

[AmiNimA]

closing the lids suspends the system, not hibernate.
maybe the problem is Graphic card.

[Haiku]

closing the lids suspends the system, not hibernate.

In default by closing the lid it suspends, but you can configure it to hibernate in the System Settings.